Jailbreak iPad 4.2 - Shortly after the official launch of the new iOS 4.2.1, our friends from the iPhone Dev Team have released a new version of Redsn0w, the 0.9.6b4, compatible with it. Therefore, the iPad Jailbreak 4.2 is perfectly possible. Although it is the type tethered ...
Warning:
This method iPad 4.2 Jailbreak the rate is tethered , which means that if we run out of battery or turn off our IPAD, we restart with a tool redsn0w procedure (as explained at the end) if we continue to use Cydia or any applications we have installed.
Although a fairly simple process is not recommended for novice or inexperienced. Jailbreak make changes to the operating system, so before you follow this guide is highly recommended that a backup so that in case something goes wrong, you can restore and return to normal.
We are not responsible for any damage that may occur to your device after you follow this guide.
Compatibility:
- iPhone 3G - unthetered ;
- iBoot old 3G iPhone - unthetered ;
- iBoot new 3G iPhone - tethered ;
- iPhone 4 - tethered ;
- iPod Touch 2G MC - tethered ;
- iPod Touch 2G model MB - unthetered ;
- iPod Touch 3G - tethered ;
- iPod touch 4G - tethered.
- iPad - tethered.
- The update iOS iPad 4.2.1.
- RedSn0w 0.9.6b4 for Mac, available at this link or RedSn0w 0.9.6b4 for Windows, which can be downloaded from here.
- iTunes 10.1.
1. Update your iPad 4.2.1 IOS normal way through iTunes.
2. 0.9.64b redsn0w run the tool, click "browse" and select the file. ipsw 4.2.1 IOS you have previously downloaded (one of the requirements). The tool will identify the version of IOS and will begin a brief process that requires an Internet connection.
3. On the next screen, click "Install Cydia" and then Next. 
4. When requested tool, go into DFU mode by following the onscreen instructions. Voilà ! Within seconds, your device will iOS 4.2 "jailbreak".
5. At the end of the process, the tool Redsn0w notify in case of system reboot or run out of battery, we carry out a special procedure to use the device :
6. And that's it! You'll see Cydia now works in landscape mode.
As a start iPad tethered mode for the jailbreak to work:
It is essential to save the file. Ipsw you downloaded and which has made this the iPad Jailbreak it will be necessary every time you want to perform this process.
1. Runs the tool redsn0w 0.9.64b, click on "browse" and select the file. ipsw IOS 4.2.1 you have previously downloaded (one of the requirements). The tool will identify the version of IOS and will begin a brief process that requires an Internet connection.
2. On the next screen, click on "Just boot tethered right now"
3. Enter DFU mode by following the onscreen instructions. Your device will restart in seconds.
4. With the resumption of the device can check whether the process has been successful, and that instead of seeing the typical Apple apple, pineapple will see the iPhone Dev Team.
We will follow this process every time we run out of battery or reboot our iPad. Perhaps it may be a bit cumbersome, but until there is available an untethered Jailbreak ... than nothing!
We personally going to wait to release a Jailbreak untethered (greenPois0n).
IMPORTANT UPDATE:
If you are MAC user you can now convert this Jailbreak tethered to untethered iPad 4.2: Jailbreak iPad 4.2 Untethered with Redsn0w 0.9.7b6.
0 nhận xét:
Post a Comment